GT4 caliper piston dust boot replacement

[GT42023]

Just been switching back to stock pads & noticed the rear caliper piston dust boots are part melted from track use.
Has anyone replaced these & can it be done with the caliper still on the car?

 

[Motorhead]

Surely it’s a simple job just to remove the pads and caliper, then you’ll have complete access to the pistons?

Jeff

 

[GT42023]

My only concern will be securing the part of the dust boots that sit in the caliper. Hoping I can do this with the pistons in place without messing about having to strip down the caliper as much of the online advice suggests.

I found this video albeit a different car & hoping I can do it as simply this

If anyone has replaced the dust seals, keen to hear if you were able to do this with the pistons still in place.

 

[Motorhead]

I’m afraid that I can’t advise, but isn’t it going to be tricky getting into the limited space between the disc and the caliper when the pads have been removed to see what you’re doing? I can’t see any disadvantage in removing the caliper to get full access, but maybe I’m missing something.

Jeff

 

[GT42023]

I'd be unbolting the caliper & removing the disc for access. I just mean to change the dust boots without physically disconnecting brake lines etc so I'm not incurring more cost on fluids etc.

https://www.design91.uk/p/porsche-9...MI-dST5duLkwMVpZVQBh06kyqxEAQYAiABEgKxlPD_BwE

 

[Arcam-Storm]

I would imagine that the dust boots could be changed without removing the caliper but it will be fiddley, block of wood against one of the piston to stop it extending and of course leave the pad in the other side, with some luck you can extend the piston far enough to swap the boot over, my only concern would be if they is a retainer clip on the outer lip pf the boot they could prove an issue to refit. I will be having the wheel off mine tomorrow to swap the BF out and will take a better look then and report back.

 

[Arcam-Storm]

I’m afraid that I can’t advise, but isn’t it going to be tricky getting into the limited space between the disc and the caliper when the pads have been removed to see what you’re doing? I can’t see any disadvantage in removing the caliper to get full access, but maybe I’m missing something.

Jeff

The reason for not removing the claiper would be just the extra work required plus a full brake bleed would then be needed, if they could be done insitu then a bleed could be avoided.