Menu toggle

KEP clutch on 944t

u63af

u63af

Member
Anyone on here running a Kep (kennedy engineering) pressure plate. Haivng read on rennlist, this together with the southbend drive plate is the best combo. It will cost me about £150 over standard set up. I am probably going overboard with this but if I ever do end up modifying the car more then at least it will handle the power. Car is getting tracked.
 
Running a KEP stage 2 pressure plate with a lightened original flywheel and 930 clutch disc on the turbo, pleased with this set up.

Some people seem to have had problems with this set up, but was apparently caused by too much crankshaft end play (worn out main/thrust bearing).
Haven't had this problem but mine was fitted on an engine with new main bearings and virtually no crankshaft end play.

The pressure plate is quite stiff and some people suggest fitting it along with a new clutch fork, which isn't quite cheap.

In any case it is important to set the biting point quite low, as a short pedal travel prevents from applying "excessive", unnecessary load on the fork which has to work against a pressure plate much stiffer than the original's.
 
I too have the KEP stage 2 pressure plate with a 930 clutch disk and am also very happy with it. It holds my 480lbft of torque with no problem and is very easy to modulate, no clutch chatter and not too heavy a pedal. As Thom said the biting point is quite low so takes a while to get used to (especially if you other car is an S2 with a 200k mile clutch that bites after about 3" of travel).

Some US people have had problems with this setup but the manufacturers state this is only on old worn engines with lots of crankshaft play (both mine and Thoms are new engines which could explain our lack of incident [:)] )
 
You must log in or register to reply here.

Posts made and opinions expressed are those of the individual forum members

Use of the Forum is subject to the Terms and Conditions

Disclaimer

The opinions expressed on this site are not necessarily those of the Club, who shall have no liability in respect of them or the accuracy of the content. The Club assumes no responsibility for any effects arising from errors or omissions.

Porsche Club Great Britain gives no warranties, guarantees or assurances and makes no representations or recommendations regarding any goods or services advertised on this site. It is the responsibility of visitors to satisfy themselves that goods and/or services supplied by any advertiser are bona fide and in no instance can the Porsche Club Great Britain be held responsible.

When responding to advertisements please ensure that you satisfy yourself of any applicable call charges on numbers not prefixed by usual "landline" STD Codes. Information can be obtained from the operator or the white pages. Before giving out ANY information regarding cars, or any other items for sale, please satisfy yourself that any potential purchaser is bona fide.

Directors of the Board of Porsche Club GB, Club Office Staff, Register Secretaries and Regional Organisers are often requested by Club members to provide information on matters connected with their cars and other matters referred to in the Club Rules. Such information, advice and assistance provided by such persons is given in good faith and is based on the personal experience and knowledge of the individual concerned.

Neither Porsche Club GB, nor any of the aforementioned, shall be under any liability in respect of any such information, advice or assistance given to members. Members are advised to consult qualified specialists for information, advice and assistance on matters connected with their cars at all times.

Porsche
Lockton
Pirelli
Officially approved
Oracle Finance
WEX Esso
Collecting Cars
Back
Top