Getting ready to replace a few rusty looking hard steel brake lines on my 92K mile Boxster.
Replaced several car's lines with copper nickle, so OK with that, but the line over the box is a bit un-clear.
Does this line run from the mid-car junction block right over the box to the rear caliper (drivers side)?
Have found Rocketdogracing's flexible hope which looks idea, anyone with experience of doing the job and what suppliers used please?
I know i need a new flare tool to do the bubble flare, rest seems pretty standard fare.
Any hints tips etc welcome.
Pic for a smile!

Replaced several car's lines with copper nickle, so OK with that, but the line over the box is a bit un-clear.
Does this line run from the mid-car junction block right over the box to the rear caliper (drivers side)?
Have found Rocketdogracing's flexible hope which looks idea, anyone with experience of doing the job and what suppliers used please?
I know i need a new flare tool to do the bubble flare, rest seems pretty standard fare.
Any hints tips etc welcome.
Pic for a smile!






