Oil pressure sender. Spanner size needed 2 remove/fit

[T3rra]

I replaced one 2 twice, but it would seem the spanner I used is no longer in the tool box . I think it's 21mm got loads off 7/8

Looks like Iv got 2 buy one 4 the job tmw. Be nice 2 get just the one.

 

[chrisjcoe]

Found this on the Clarks site, does this help? I need to do this soon too!

Using a 15/16" or 24mm stubby open end wrench, loosen the oil pressure sending unit.

 

[edh]

"stubby" is a good tip

I cut down a spanner just for this job as there is very little room for access. I think a normal length spanner will hit the ARB.

 

[zcacogp]

It will hit the ARB. And the steering rack. And the ARB mount. And the bottom of the engine mount. And the sump. And the undertray (but you can get that off). And pretty much everything else in the known universe.

(But it's not impossible!)


Oli.

 

[T3rra]

Thanks that's what I needed. 24mm found if you take the oil filter off its not 2 bad.

But Iv done it from below remove the front bumper, others wise your all twisted up in between everything like mentioned