Turbo Engine Rebuild
- Thread starter scam75
- Start date
scam75
Well-known member
Well that's the lights fixed now, 2 x bad earths for the fogs and 1 x gubbed indicator unit was to blame.
Get it back later then need to swap over the temp gauge for my spare one as it's been going mad and change over the trim that houses the clock and hazard switch as the hazard switch has sunk into the dash board (luckily I have a spare trim and switch)......then i might put on my shiny new set of wheel nuts as a finishing touch. Exciting!
Stuart
Get it back later then need to swap over the temp gauge for my spare one as it's been going mad and change over the trim that houses the clock and hazard switch as the hazard switch has sunk into the dash board (luckily I have a spare trim and switch)......then i might put on my shiny new set of wheel nuts as a finishing touch. Exciting!
Stuart
blade7
Well-known member
No slight was intended, and for what it's worth the colour, sunroof delete and wheels on your car are pretty close to my ideal spec. And no doubt the paint is better than on my car now. I still reckon the ride height is too low thoughFair enough, it's easy to get defensive with all the time and effort I've put in lately with engine and body work!
.
scam75
Well-known member
It is too low, I concur. You do get used to taking speed bumps at 3 mph after 15 years.....
As you will be well aware, it would need re-indexed at the rear, a job I have not undertaken yet nor have the appetite to do any time soon! It's something I will do eventually to coincide with a suspension refresh once I've had a couple more years out of my newly refurbed GAZ Gold units.
When I last had the geometry set-up done, I asked if they could lift it a little on the rear eccentrics, but there was next to nothing available to use.
Stuart
As you will be well aware, it would need re-indexed at the rear, a job I have not undertaken yet nor have the appetite to do any time soon! It's something I will do eventually to coincide with a suspension refresh once I've had a couple more years out of my newly refurbed GAZ Gold units.
When I last had the geometry set-up done, I asked if they could lift it a little on the rear eccentrics, but there was next to nothing available to use.
Stuart
scam75
Well-known member
I can be lifted a bit no problem on the front with the ride height adjustment, it will be going for another geo set-up at some point soon as both front shocks have been removed, fixed and replaced since last one, and just set up as near as possible by eye. So it's on my to do list.
Having been there, done that, I was very glad that I didn't need to drop the entire rear subframe again to reindex it after my recent rear end refurb. It measures the same both sides to the top of the wheel arch, I did it by eye and some strategically taken photos before I took it apart. It is however a real PITA trying to get the torsion bars back into the housing in the right position and that is with everything refurbished and new bushings... If it needs adjusting, I will leave it to the suspension guys when I eventually get it all aligned.It is too low, I concur. You do get used to taking speed bumps at 3 mph after 15 years.....
As you will be well aware, it would need re-indexed at the rear, a job I have not undertaken yet nor have the appetite to do any time soon! It's something I will do eventually to coincide with a suspension refresh once I've had a couple more years out of my newly refurbed GAZ Gold units.
When I last had the geometry set-up done, I asked if they could lift it a little on the rear eccentrics, but there was next to nothing available to use.
Stuart
scam75
Well-known member
Indeed David. Anyway, a job for later. Car is now back. Was sitting fully valeted, painted and fixed, waiting on me and the heavens opened on the way there, also a bird took the opportunity to put a big rotten dump down the drivers door. Thankfully it was removed with ease on a soaking wet door. Car now home and looking pretty ready for the previously mentioned minor works and all is good for this moment in time. I love my old car. For now............
Huge shout out for my paint guy who kept to his original quote when things went way above and beyond the original estimate, and also paid the spark and the window guy, as well as fitting the valance support and bonding hockey sticks and doing the full sides stone chip that were not mentioned at the start. And doing a fab job. Happy days.
Huge shout out for my paint guy who kept to his original quote when things went way above and beyond the original estimate, and also paid the spark and the window guy, as well as fitting the valance support and bonding hockey sticks and doing the full sides stone chip that were not mentioned at the start. And doing a fab job. Happy days.
Posts made and opinions expressed are those of the individual forum members
Use of the Forum is subject to the Terms and Conditions
